ColocatedServerConfiguration

From IntuixWiki

(Difference between revisions)
Revision as of 10:09, 10 June 2009
Sia (Talk | contribs)

← Previous diff
Revision as of 10:12, 10 June 2009
Sia (Talk | contribs)

Next diff →
Line 2: Line 2:
==== General ==== ==== General ====
 +
 +- we're installing servers in two post racks; please provide 2-post rack mounting hardware; if you require a shelf - please notify us beforehand
 +
 +- Intuix LLC is providing all cables EXCEPT power cable; please provide power cable with your system (NEMA 5-15P to IEC-320-C13).
- please label your server with system "handle" (as assigned by Intuix LLC) on front and on the back; if available - please add mac (ethernet) address of primary (internet) interface; for example: "handleA - mac ab:cd:ef:12:34:56" - please label your server with system "handle" (as assigned by Intuix LLC) on front and on the back; if available - please add mac (ethernet) address of primary (internet) interface; for example: "handleA - mac ab:cd:ef:12:34:56"

Revision as of 10:12, 10 June 2009

Contents

Colocated Server Configuration

General

- we're installing servers in two post racks; please provide 2-post rack mounting hardware; if you require a shelf - please notify us beforehand

- Intuix LLC is providing all cables EXCEPT power cable; please provide power cable with your system (NEMA 5-15P to IEC-320-C13).

- please label your server with system "handle" (as assigned by Intuix LLC) on front and on the back; if available - please add mac (ethernet) address of primary (internet) interface; for example: "handleA - mac ab:cd:ef:12:34:56"

- optionally add label with your company name and contact information

- label network ports - especially if manufacturer labeling is wrong

- if your system has multiple serial ports - please label console port

- please label hard drives, if they're removable, especially if your system has multiple drives; label each drive with your system handle and drive number, i.e. "handleA disk#1"

BIOS Configuration

* enable USB support and Legacy USB support, so we can use USB keyboards
* ignore POST errors (especially keyboard, floppy, etc)
* set "Power loss" mode to "Stay on"
* enable BIOS console redirection if available: 
   * COM1 (COM A)
   * Speed: 9600 baud
   * Console type: VT100, 8bit
   * Flow control: none
   * Connection type: direct connection
   * Continue redirection after boot: yet (sometimes also called "Run Agent after boot")

We can accommodate different speeds for serial console; above are default settings.

OS configuration

* turn on OS serial console on serial port 1, with settings as above

Configuring serial console:

Linux: http://www.vanemery.com/Linux/Serial/serial-console.html

FreeBSD: http://www.freebsd.org/doc/en/books/handbook/serialconsole-setup.html